Polar_Ted

V0 Two Piece back panel with vents

2

* [x] The mod, firmware configuration or slicer profile is in the correct category folder. Printable mods go to `printer_mods/`, firmware configurations go to `firmware_configurations/`, slicer profiles go to `slicer_profiles/`....

Add code for endstop state and RPi host and MUC temperature sensors?

6

I would like to have a temp status light for MCU and Pi Host CPU temps. An endstop state would also be useful. This is the line in printer.cfg that...

* [x] The mod, firmware configuration or slicer profile is in the correct category folder. Printable mods go to `printer_mods/`, firmware configurations go to `firmware_configurations/`, slicer profiles go to `slicer_profiles/`....