Peter-van-Tol

pauluzs commented... "Been running it as a mesa 7i90 card with hostmot2 firmware over spi to linuxcnc on a raspberry pi 4 for several months without any problems." I'll second...

This would make this library so more flexibel!

It is worth to mention that the buffers (`74HC245T`) are not 5 V tolerant either when driving, so the peripherals should be also driven by 3.3 Volts in this case....

I think this should be possible to be automated using GitHub actions. The dependency-graph for `liteeth` is: `litex` -> `liteiclink` -> `liteeth`. In order to have this package automated for...

Drom the three libraries mentioned above, which ones are still invalid? When making them valid, is there a wish to move away from setup.py and go for a more modern...

Sounds like a good plan. Bsed on the list, I would be more then willing to create PR's. My project LitexCNC would become much easier to use when the updates...