PJawZK
PJawZK
Haven't been able to do that, cause of the constant "Z:TRIGGERED" issue. But I will look into and see what that S-7 spits out in terms of information
It reacts to changes from going closer and closer to the material. Mid-air value 952, going down incrementally as I move closer to the metal surface. Lowest value 11, says...
I'm running a Dual Z-axis setup, 2 z-motors on different drivers
So looked a bit more, the issue of not homing properly was due to my use of the [homing_override] and my badly implemented macro, that set the Z-axis as homed...
I have, seemingly, gotten it to work with a lot of troubleshooting and changing settings, as well as going over wiring a bunch. I used both the wire loom and...
I will look into the pins more, and see if it was something I missed there
The EXP1 port function works now as well. So no hardware issues. Just bad config files it would seem, from all of my issues. From my end, not yours. Unfortunately...