Oli

Hallo Olli,wenn Du magst, könnten wir andere Nutzer bitten, die von mir beschriebene Messung ebenfalls durchzuführen und die Werte zu übermitteln (die müssen ja nicht den Kühlkörper runter reißen), dann...

You have to measure the voltage between GND and the potentiometer of the original driver (A4899) (take a look at the attached images) Take care that: - the power of...

> > Can i use this vref for a mega S? Best would be if you measure the vref voltages of the original drivers and publish them here then we...

> Does anyone use the TMC2208 from Watterott? The chip + potentiometer is on the downside of the PCB. How did you basically adjust the voltage and where did you...

@gabber13077 Printer: Mega X Board: V0.0.2 >Board Label | Voltage >-- | -- >E1 | 1.15 >E0 | 1.10 >Z | 1.15 >Y | 1.19 >X | 1.13 When these...

I created an average of the Vref values from phlipse and EasyG0ing1 (and mine), the maximum current and the Vref for the TMC2208 to initial post. As you can see...

last chang on march 3nd, 08:03 Turn streamer on: aircon/set_special_mode ---------------------------------------------------------------- GET /aircon/set_special_mode?lpw=&en_streamer=1 HTTP/1.1 demand control: /aircon/set_demand_control ---------------------------------------------------------------- the following options all have to be set when sending set_demand_control: en_demand=0...