MattP

What did the monitor look like that didn’t display well? Did that one work with C1?

sounds good, i uploaded a new one just now that may be slightly faster. i also realized that the last one was compiled in my experimental clone, not the minimal...

Yes, if you want to compile it it's a little more complicated at the moment. If you want to join the effort to fix it so it can compile properly,...

Sorry, that comment was for Pablo, I just replied to your comment @Marcinoo97

@PabloIvnGl https://github.com/NumberOneGit/rpi5-uefi/issues/1 Respond to Issue #1 in the main Issue on the new RPI5-UEFI fork and I will reply there

@Botspot This issue is resolved now as long as any users install 6/9 EEPROM update.

I’m experiencing the same issue with my CM5 and the official IO board. If you take the same properly set up CM5 module and test it on a CM4 board...

To clarify, I was referring to CM4 3rd party carrier boards that use a USB2 connection that has a USB-C connector to supply power. I can get gadget mode to...

Piunora and Seeed Studio Dual Gigabit Ethernet both work without issue on OTG on my iPad with a CM5. As mentioned, I can swap the same CM5 module from the...

@jclark Once I had an early boot UART connector on my CM5, I realized that the CM4 boards were only working because they have 5k1 to ground resistors on CC...