Noobman
Noobman
I only installed java development kit and java3d, as i took the liberty to write on reprap pcbmilling page. Normally it runs fine and without errors, so i think there...
Again "aha" - i thought the stuff is done in 2D, didnt even realized its 3D until you told me to click the tilt button. The pads are smd (1206),...
Aha i understand now, i could change the 1206 footprint to have circles instead of rectangles, and then when voronoi paths are created, it wouldnt matter because the created shapes...
I did changed the smd footprint to ovals and that solved most of the problem. Uh, again totally sux at coding. Is there in java3D some method that can fillet...
Ok, but i kind of got too much on my plate already irl - and that is without trying to dive into java :)
Dunno, in my case it seems to be done at the same speed. I see them as G0, but i should look at how my setup interprets F123, for some...
Aha you are right and i will check and patch the G0 on my firmware with max_ speeds. Indeed this makes a lot more sense than my initial thoughts. Thanks...