Nomena2392 comments

Repositories
Issues
Comments

Results 4 comments of


                                            Nomena2392

Using high and low latency links in parallel

Hello @stephendade .I am a beginner in the subject, I would like to know how to activate or send the command MAV_CMD_CONTROL_HIGH_LATENCY by Mission Planner if possible. I would like...

Using high and low latency links in parallel

> > Hello @stephendade .I am a beginner in the subject, I would like to know how to activate or send the command MAV_CMD_CONTROL_HIGH_LATENCY by Mission Planner if possible. I...

Using high and low latency links in parallel

@stephendade Thanks for the instruction. I used the command "link hl on" , but there is the message "MAV_CONTROL_HIGH_LATENCY command not supported" in MAVProxy.. And when I log in to...

Using high and low latency links in parallel

Hi @stephendade I managed to enable High latency mode on mavproxy.. I was using the old version of Ardupilote, but it was enough just to update the firmware.. But there...