Noisyfox

Just curious, is there technical difficulties to make it work with Classic walls?

I noticed that when this option is enabled, it ignored the wall order settings:     As you can see, the outer wall is printed first even I...

> @Noisyfox It does ignore the wall order setting. And that is by design. So all the non-staggered (lower) perimeters are printed first and then the staggered (offset by half)...

> > > @Noisyfox It does ignore the wall order setting. And that is by design. So all the non-staggered (lower) perimeters are printed first and then the staggered (offset...

The strong tree algorithm is somewhat computational & memory intensive while unable to be parallelized, and I haven't find a way to improve it yet.

> Right now it cuts off at `blahblah at layer:` then you can't see the layer number. A little bit wider and we'd at least see the layer number incrementing....

会修，但是要等下个月

https://ci.appveyor.com/project/Noisyfox/act-ffxivping/branch/master/job/rgab0ood3e94fdvo/artifacts 试一下这个版本呢

I think the problem here is the model size changed after the repair, which lead to the offset of the connectors. If you don't fix the model, you will notice...

What you need to do is place the model perfectly flat on the plate, by using:  Then you can cut it perfectly without the need of model fix