NezSez

@GadgetAngel : Thank you for all your work; very tedious (among other adjectives) what you've done, but you've probably rescued 1000's of users of BTT boards! Well 100's in any...

@GadgetAngel As you have written, so shall it be done! Within some definition of "margin of error." I have not updated the firmware on this board yet, so the SD...

@Cabinfourus I can't help you with your relay issue, but you should adjust settings according to the post from thisiskeithb in this issue [Marlin 21356](https://github.com/MarlinFirmware/Marlin/issues/21356) for the EEPROM. I have...

@agenttatdaddy I am also installing the relay v1.2 and mini UPS on an E5+. How did your plan with the order work out? By putting the UPS first in line...

Flash the original firmware.bin which came with the stock SDcard back onto the board, assuming the usb connection worked originally with it and that it successfully flashes. If you can...

It would save a LOT of debugging time, and improve the reputation of BigTreeTech, if they would provide the Marlin config files they used (Configuration.h, Configuration_adv.h, config.ini, etc) to generate...

It is a bit confusing, and there is some interplay between the following settings, among others, and some question as to what gets applied exactly when. It is not so...

Excellent job, just skimmed it. Thanks for puttin' the time n' effort into it. Plan to submit it to the Documentation project?

https://3dprinting.stackexchange.com/questions/8153/how-to-set-z-probe-boundary-limits-in-firmware-when-using-automatic-bed-leveling On Sat, Feb 6, 2021, 16:50 ManuelMcLure wrote: > And explaining all of the corner cases, like printers where the end stops > don't actually allow the nozzle to...

Was any decision or progress made on this?