MrChromebox
MrChromebox
> [rChromebox](https://github.com/MrChromebox) Cool! Is it with WiFi support you mentioned earlier? it's with whatever iPXE supports. Atheros adapters should be supported, Intel ones which need a firmware blob are not
> Read some things about building with `axge--ncm--ecm` but still have to figure out where to adjust these build options while including in EDK2. around line 17 on payloads/external/iPXE/Makefile
closing as all ChromeOS boards with onboard LAN now have iPXE support as of 2509.4. If there is additional functionality which is desired, please open a new issue
you have a board picture for DRAWPER? AFAIK they are the same
can you provide a clearer picture of the jumper block in the upper left? It's likely one of those two. The HWWP marking does not appear to be a label...
> assuming you mean these correct >is it the rightmost pair? there's no way to determine that without the schematics other than trial and error
> whats the worst case if its not, most likely that the device will still have WP enabled > also would suzyq work in shimmer? i cant enable devmode without...
again, no idea because you've used shimmer and your device is in a state I'm not familiar with
agreed, I would reflash the UEFI firmware here before rebooting
thanks! which pair of jumpers need to be connected? Can you provide a slightly closer pic of the area?