MickTheMechanic

How did you go with this? I am now introducing a rotary coder into my tire tool project. A simple example would be awesome.

First of all, for almost every issue I have opened I have attached a sample code, to say something like that is a bit rough. I have been hammering away...

I have checked your sample, and in the input field I see this: „%$%‰š£‹˜ûêŽ This confirms what I am saying. When I type Ä I should get the character for...

I also forgot to mention that the builder does not output the correct ASCII character to the c code. Example: I input ° in the builder, and I get ▓...

That seems strange, as I entered º by holding alt and typing 167, so it should have been an ASCII character. I found the character map, that part is working...

I have tried STLink programmer and STcube programmer. I have tried the following files from the CortexM0 folder: Firmware_dist_calculation_fast_boot.hex Firmware_dist_calculation_fast.hex Firmware_dist_calculation_simple.hex Firmware_raw_capture.hex Each upload appears to be sucsessful, but no...

I checked the documentation again, I think i have made a mistake. When using the programmer which file do I select?

In the STCube software which baudrate should i select for the uplaud via UART?

I cannot connect, i have the error message: ``` 17:07:15 : Serial Port COM4 is successfully opened. 17:07:15 : Port configuration: parity = even, baudrate = 115200, data-bit = 8,...

I have tried both connections, but i cant get the connection to work. Is it possible i have damaged the bootloader somehow?