Miami Mike
Miami Mike
When I use Compare Models it's usually to compare a model setup in my radio, which I may have altered at the field, to that same model's setup in the...
Example: playNumber(123, UNIT_VOLTS, PREC2) should say "one point two three volts" but instead says "one point nine volts". This happens in Companion simulator and on a Taranis X9D+.
I have a current sensor that I sometimes install and sometimes don't. I discovered this bug while trying to set my radio up to say "current sensor detected" when my...
On Companion's Outputs, Logical Switches, and Special Functions tabs the column labels are attached to the tops of the columns so that when you scroll down they disappear off the...
Using Windows 10, set up a model checklist to appear when Simulate Radio is selected. Then close the simulator without first dismissing the checklist. Companion stops responding and can't be...
In Companion 2.3.15 Compare Models, differences in telemetry screens don't show up in green and red.
Differences in Telemetry Screens (Custom Screens) are not highlighted with green on the left and red on the right. Radio setting: Taranis X9D+, Didn't try other radios.
This appears to be related to issues [8703](https://github.com/opentx/opentx/issues/8703) and [8705](https://github.com/opentx/opentx/issues/8705). Apparently the fix was unsuccessful. 1. Set up an input with a sensor as the source. In this example the...
This is another issue that [I raised in the OpenTX GitHub forum](https://github.com/opentx/opentx/issues/6483) which was ignored and eventually marked stale. When you set up haptic vibrations in Companion, either on the...
If you want to use the joystick at the lower-left corner of a Horus X12S, it shows up as input selections "JSx" and JSy", and I'm told they work properly,...