Mech131

Anyone?

@thisiskeithb I am using a genuine BLTouch. Version 3.1

> @ellensp Attached is the TXT of the failure. It happens at the bottom [Debug BLTouch Fail.txt](https://github.com/MarlinFirmware/Marlin/files/8896961/Debug.BLTouch.Fail.txt) .

@ellensp Is there anything else you need to address this issue? I see that the 'Needs: more data' label is still applied.

Hello @Triangulix, We've had users swap out their cables for shielded ones with no improvement. Also, the probe works fine with the Creality board or a different version of the...

@digant73 Turning on BLTOUCH_SET_5V_MODE made the issue worse. Are you sure it's suppose to be on for the BigTreeTech E3V3 board? I disabled Advanced_OK, flashed the firmware and still have...

@DickQuaif In the past when I have tested out the 5V mode, the problem has gotten significantly worse. I will try adjusting the firmware to have both `#define BLTOUCH_SET_5V_MODE #define...

@DickQuaif If you ended up leaving 5v mode off, Then what's the point of flashing the firmware with BLTOUCH_FORCE_MODE_SET?