MazenS

I've also tried the config suggestion here but no luck. https://github.com/procount/pinn/issues/367

Hello! Apologies for the lack of clarity. When booting into the pinn menu from a freshly installed sd via the rpi image program, nothing is being displayed on my above...

I was on my phone last night - not the most conducive to well thought out posts. ``` gpu_mem=16 start_file=recovery.elf fixup_file=fixup_rc.dat [pi4] start_file=recover4.elf fixup_file=fixup4rc.dat max_framebuffers=2 #hdmi_group=2 #hdmi_mode=87 #hdmi_cvt 1280 800...

This is the device: https://www.waveshare.com/10.1inch-hdmi-lcd-b-with-case.htm And I found the display instructions here: https://www.waveshare.com/wiki/10.1inch_HDMI_LCD_(B)_(with_case)

Ok I'll take a look after lunch. I'm a bit of a noob - maybe not a bit - could you explain a little more what I should experiment with?

So after some fun and games learning about SSH I have the following From tvservice: ```state 0x6 [DVI DMT (87) RGB full 4:3 x2], 640x480 @ 59.00Hz, progressive``` From fbset:...

I commented out the relevant lines from PINN. When I ssh back in I'm seeing similar reports: ``` root@recovery:~# tvservice -s state 0xa [HDMI DMT (4) RGB full 4:3], 640x480...

I'd love this feature - I'm looking to change equipment soon and would love to be able to take my settings with me

Of course - first time I didn't do the redacting properly > Could you post your (suitably redacted) config.py file? provisioned = True nickname = 'grow' wifi_ssid = 'WIFI' wifi_password...

> Could you post your (suitably redacted) config.py file? Checking in again to see if you can offer any help or pointers?