MaxMarschall

There's still something fishy with this. Each time I try using that custom boundary there appears a buoyantBoussinesqSimpleFoam.log that has this message in it: > Radiation model not active: radiationProperties...

@DambronOlivier , I am...but it's funny, I opened your file and also used multiple processors and everything worked out fine.

@mimarilker @DambronOlivier , Which model are you referring to - my original one or Olivier's? I think the unusual numeric domain is usually due to probe points lying outside boundaries...Not...

Here I've used the default BF inlet boundary condition component for an opening top right and an outlet bottom left:  Above is in Rhino at time step 150, below...

Hi Theodore, I ran it once with the surface of the inlet flipped and it turned out the same:   In both cases I set the _velocityVec of the...

It looked just the same when I entered a Z vector with the inlet component, and again the same if I try the custom component, be it `uniform (0 0...

Unfortunately not, I tried out a whole lot of things but it always turned out the same...I'm moving countries atm and won't be able to continue with this for at...

Dear @TheodoreGalanos, Thanks for your help. That does sound like an option although of course it would be great if there were another way. Also, do you think there could...

I have been getting the same error, usually after like 2 timesteps...

Dear @mostaphaRoudsari and @TheodoreGalanos , As far as I understand, wall shear stresses can be used as an indicator of the wind directions near surfaces. Since the wind speeds on...