Mats1717

Hi Olalid Below works for me but the slave charger has a delay for about 5 minutes before it changes. Master update directly when new hour. alias: Elpris Easee Garaget...

Ok. Not a big problem.Just wanted to report what I been seeing👍Skickat från min iPad25 okt. 2023 kl. 16:42 skrev Ola Lidholm ***@***.***>: Ok, I do not think there is...

What do you think of using switch.easee_garaget_charger_enabled. Is that a bad idea.

The slave is not updating, but it have the value set shown on master. Had this config for some time. Se below 

It will use the value of the master but i dont think it will update anyway when charging. I use charger_enabled for automation by schedule so it wont update so...

Do you have the chargers on the same circuit master and slave? I have them on same circuit and need to use Switch turn off on the other charger

You can have the. Installer på make booth masters. That will work. Had it for a time with the new lite when Easee was not ready with firmware. Ursäkta engelskan😃

On site as masters booth. Then you have 2 different dynamic values. I am not using the off mode more than once a day so hopefully It don’t wear out...

Ok, I don’t use this application, using nordpool shipest hour and my automation. But the question about dynamic i am quite sure about, master master and you can control it

> > @Mats1717 Tried to find any info on how to set both chargers as `master`, but couldn't find it. Do you know where I can find it? > >...