MarkusThur

@thinkyhead Thank you for the answer. As I am in the lucky position to have a 8bit Trigorilla and a 32bit SKR Pro aviable and was going to test the...

@RipperDrone thank you for your input, this fits to what I am asuming, and will look for in the code. 25mm/s shouldn't be too much, especially as you shoudn't need...

@RipperDrone I looked into it, on first view nothing directly strange. On second view I have some questions to your settings: The E feedrate is limited to 10mm/s, the Hemera...

@RipperDrone Then let's try following; Your calculation for the steppercurrent is right, if Irms is set in the register of the TMC 2209. Am not 100% sure, if it sets...

Got a visualisation for trapezoid accelerated movement. (on S_curved movement, I'm still working). https://www.desmos.com/calculator/isogmb9uzz?lang=de I did preset values from your screens. ``` a9999 = max x/y acceleration 500 mm/s^2 v9999...

@RipperDrone I tonight also had those wired sounds. And some more thoughts on it. And now I see you print, which is pretty nice. What I had is, I generaly...

@RipperDrone Where we are at the beginning point. :-)Something strange / unexspected happens. But I think it's good to talk about it. And once I am prepared, with the thoughts...

@RipperDrone I continued testing and calculations during the week. Yes, Lin_advance shall and does remove the overshot on edges. if you want to reduce without linear advance, the trick is...

@RipperDrone admentment from observing my printer, now knowing, what I wanna look for: Higher Jerk leads to less / no retract from Linear advance. Slower speed leads to less /no...

@RipperDrone @thinkyhead After I changed my bearings on the Extruder today as I wanted to test something, I was "able" to produce "strange" noises with it on retracts. Or more...