Makurisan
Makurisan
I dont know why but the GetPortStatus is not completed: 00> HUB Get Port Status: addr = 1 port = 5 00> Control Setup: A3 00 00 00 05 00...
moved to fist post
1. No I didnt implement or changed on hcd_frame_number. 2. Yes, I do it if I saved my tests. 3. Yes, I did test it with different hubs but always...
 As I mentioned after the call of port Reset from usbh.c at line 739 and following lines.
Hm, I think it is long enough. In the usb 1.1 spec it is said that a port reset on a hub is nominally from 10ms to 20ms. If I...
Which board you use normally to check the OHCI hub code?
Yes, it is really interesting that the samg55 use OHCI. I tested it because I want low speed. I don't know if you know but low speed has some specialties...
Now I came up width the following solution:  
Yes, it goes in the same direction. One problem is that if you change a cell width in a grid e..g. to 1200 the whole dialog goes very large but...
I made a double check and I forget that the second monitor has also changed the dpi. Now, if all my monitors are on 100 there is no problem. I...