MadTooler

> Oh, I missed that you asked for lasers not for self build embroidery machines. I don't think we output stitch commands to laser mode gcode. But that's what you...

> Some time has passed. Is this still an issue in current Ink/Stitch versions? Thanks for the follow up. I do not know about @Duguest, but I believe it worked...

My vote for this feature as well. Although, feature really is not the accurate label. Without the ability to have first layer printed all at the same time, sequential printing...

Hello again! @bartbutenaers Personal life tends to do that. The older I get and the more life expands and gets in the way of my tasks, the more I wonder...

> The possibility of other hiccups resulting from N duplicates may bite me later with the multiple things I am asking the svg nodes to do at once. I will...

Thank you for the reply. No luck with adding the suggested lines. Not sure if the way I found formatting them for NodeRed to accept them without throwing an error...

If svgDOM is loading as an ESM module (I am not sure if it is or not with my limited understanding), a note I found from one of NodeRed's developers...

... furthermore, I have noticed some gcode runs fine, then, another work offset setup with the same code has the issue. I bet the minor zero position offset variation, due...

Thanks for looking into this. I do believe it is quickly cycling spindle off then on again when ends the initial path and begins the next returning path that goes...

$9 is set to 3 per your direction here (https://github.com/grblHAL/RP2040/issues/47) with only a single pin for spindle on/off I definitely do not expect any debug of an older version considering...