MacDaddyFPV
MacDaddyFPV
Camera detection has been setup and camera is being detected on pi3b+ bench test. Camera is not being detected on pi4b due to an i2cdetect issue.
As the VEYE cameras use custom software to run the camera, it is not able to be used in the standard gstlaunch pipeline. V4L2 driver method is being investigated.
V4L2 drivers are not available from VEYE for the 4.19 Kernel so this will not work on the current Buster version. Investigating if it will work for Bullseye.
Bullseye is using the 5.10.0 Kernel which there are still no drivers available from VEYE. We would need to upgrade the Kernel to one that has a driver for this...
Hi CkovMk, I do not think there is a plan to support this yet. If you can look into developing this it would be gladly accepted by the project. Thanks
VEYE camera detection is implemented and has been tested on the VEYE IMX462 on a RPI 3b+. The pipeline to run the VEYE cameras with the new pipeline setup is...
Initial testing shows that libcamera is not recognising cameras. This will need to be fixed before any camera detection is put in place.
> Nice to see that development is going on! > I started the new image and the air unit is nicely comming up but groundstation stopped initialization with "no wificard"...
Milestone image boots on Pi4 but will not boot on Pi3b+. Replacing the Kernel with one from a previous image allows it to boot so I suspect an issue in...
I looked into this further. I was able to get it to boot by replacing the bcm2710-rpi-3-b-plus.dtb file from a standard rpi os lite image so I suspect we are...