MUN0X
MUN0X
> I have to admit that everything seems to be working fine now, apart from the one issue that is when changing from any of the modes to heating mode,...
Nice! Missed that introduction completely. Might have to redo my heating dashboard now 😀
I had this issue after upgrading to 11.2 so I stayed on 11.1 for now. Will try 11.4 and see what happens. Running Home assistant on a Yellow. UZB firmware...
Problem still persists in 11.4 Here is the output of dmesg | grep -i usb: [ 0.112239] usbcore: registered new interface driver usbfs [ 0.112302] usbcore: registered new interface driver...
Have you tried setting all units to 100% and then changing the value of just one indoor unit?
> More weird things are happening: I set all units to 100% in the Onecta app and I can see in Faikin MQTT messages 100%. But in the info status...
> I had a similar issue with my 3MXM40 a while ago. I fixed it by sending every change in demand control to all indoor units connected to the same...
Did you combine it X50A with power from X35A as explained in the [wiki](https://github.com/revk/ESP32-Faikin/wiki/Wiring) ? Its a P1P2 unit so perhaps P1P2MQTT could be an option if you can't get...