Thomas Behrend

So first of all, the picture that is rendered has only a 72dpi resolution per default I think. Set HoritontalResolution and VerticalResolution to what need or you end up with...

I use the http://labelary.com/viewer.html online viewer, the Documentation of ZPL and just design them per hand. When I´m finished, I print a testlabel out manually and if everything is ok....

Maybe not, on Wikipedia, the Code 11 explanation says there are different bar widths for left, middle and right. How can a scanner read this though?

Possible solution could be printing the Numbers above the Barcode Layer and add some White Space at starting and ending of the Numbercode. Or the solution you showed but I...

When you open the Sketch in Arduino Studio and import the sketch (ino) it says the sketch has to be in a subfolder, then it creates the subfolder and moves...

In theory, when we dump the transmission pin, but why, this is against the idea of the project.

Hm, at first thoughts, you would need to proxy the sensor and sent in your own particle data. Driving the LED itself could work too, but I have no spare...

This should not happen, the Config seems to not load correctly. You could add some serial log entries into the sketch and print the settings over the serial monitor.

Thx for the trick, but seeing the second sensor or be able to change the config would be something that you maybe need to do more often.

> @LordPinhead I switched to DSPHOME in home assistant and after a first flash the firmware (and configuration) can be updated over wifi. It's more comfortable. With Arduino Studio, you...