Michael Lohrer

I just had need to use a Due again and came back to this flash waiting issue. I can confirm these changes work for my Arduino Due! It looks like...

Are either of you guys powering an audio device via the rear USB ports on AmpliPi? There is a known issue where plugging in say a Chromecast Audio to the...

@linknum23, should we consider showing up to 6 expansion unit firmware versions?

Thanks really belong to @sepffuzzball in providing some possible uses for Home Assistant controlling AmpliPi https://github.com/micro-nova/AmpliPi/discussions/206#discussioncomment-2140029. TTS anouncements would be awesome!

A possible TTS implementation would be https://github.com/coqui-ai/TTS. I tried installing with pip on a Pi but it failed, looks like we'll have to do a manual install due to some...

When no input is connected: AL1_R rises to at least ~3.7V. It's hard to measure because it collapses when probed, but this is the value on C62. The other side...

The above comments are for old hardware and have been fixed. See [the preamp board's schematic](https://github.com/micro-nova/AmpliPi/blob/main/hw/sch/preamp_board/preamp_board_3a.pdf) page 2 for the circuit. This is being worked on in the `peak-detect` branch....

Yes it is possible manually edit the config while ssh'd in. You'll need to stop the amplipi service first though. To do a full factory reset of the config: ```...

I tried connecting with my (plexpass) account and am getting what I assume is the same issue. I setup a new Plexamp stream, then set it as the stream for...

Looks like Plexamp 4 brings back remote control, so we may be able to get a headless version working again. https://forums.plex.tv/t/plexamp-release-notes/221280/38