LeZerb

On https://www.descentbb.net/viewtopic.php?t=19061 I found the USB descriptor of a FFB USB wheel. Maybe this is helpful as a reference. I recently dusted off my adapter and tried to use my...

Would you or @tloimu be interested in my wheel. Since I don't think I'll be using it I could send it to you if you are somewhere in the european...

I started to look into it. When I only connect Rx I see some raw messages coming in but I am not sure if these are correct. When I connect...

One additional note. During initialization I am getting this information. device status: extra info: firmware 1.1[3c17].1[3c17], jumpers 0x0f Could this issue be related to the jumper states? Maybe one of...

I have been able to get it to work by inverting the signals between the ESP32C3 board and the Ebus Adapter v2. At least I am now getting "eBUS signal:...

I have found a solution. For a more detailed description you can have a look at [the discussion in the eBus repo](https://github.com/john30/ebusd/discussions/978) (in german)

It would however still be nice to have the possibility to configure the Rx and Tx pins in a more user friendly way.

I did just run into the same issue. The problem in my case was that I omitted the fuse option allow_other as in `ffmpegfs --log_maxlevel=TRACE '/run/user/1000/gvfs/smb-share:server=desktop-8mjh95v,share=aj%20(kp_centi)%20-%20xld%20rips' '/home/aj/ffmpegfs-out' --desttype=ALAC --log_stderr -o...