Kornelius777

Is there any progress on this issue? I just ran into this after a new install Mail was sent to three users: To root, to set and to escape...

Ich habe bei mir: `r,,temp_vorlauf_ist,Vorlauf Istwert,,,5022,280d00,vorlauf_ist,,UIN,10,Grad Celcius,Vorlauf Ist-Temperatur,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,` `r,,temp_vorlauf_soll,Vorlauf Sollwert,,,5022,b80200,vorlauf_soll,,UIN,10,Grad Celcius,Vorlauf Solltemperatur,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,` Grüße!

Just found out that this error message just appears when trying to move a LXC Disk to the CephPool. Is there any way to use Ceph for LXC? How would...

Meanwhile, I have - wiped the SD Card and re-written the 15.5.0 files on it (edited the wlan.ini, of course), - gone through the installation routine (initial setup of alignment,...

To me, it appears as if this behaviour only exists when you first start version 15.5.0. After the initial start, I accepted the reading being 1 m³ too low, adjusted...

Works nicely. Previous Value had been saved, update works flawless. Current Value correctly read. Thank you very much!

I would like to support this request! My server runs in the local timezone. However, the endlessh log is in Zulu Time PLEASE let me decide, in which timezone the...

Wellll.... It wasn't too complicated... in endlessh.c, just replace "gmtime_r" with "localtime_r" make, make install Done.