Jacob Myers

@nullstalgia My config is running fine and I also use TMC2208, so I'd either point to some other weird SD issue, or try comparing your config to mine

Ahhhh, that's just a VSC issue. See #932. That will fix it

The reason my pin is set to PA13 is because that's what I wired my driver to. You need to find what UART pin you've connect the e driver to....

@Failure2Society that issue is usually cause by choosing the wrong board version (4.2.2 vs 4.2.7) or not resetting eeprom after flashing. @JayBee-git Did you end up resolving the issue? If...

@cmadon You are correct, this will reset all your settings. Either save them with an M503 command to be re applied from the terminal, or write them down somewhere before...

This is a very interesting issue. I would be interested if this also applied to manual mesh configs as well. The only issue with this change is the fact that...

@Schnabulation Sorry it's taken me so long to get back to this. Just a question, when you have commented line 1047 out, can you test going into the z offset...

I just need to check for myself to make sure the bug I'm thinking of won't be an issue. I think it mainly happens if the mesh point at the...

If the probe is not triggering properly that is not a firmware issue. Its a hardware issue. There are many threads looking into the problems with Creality boards and bed...

I'll check if it's still an issue on the latest source