JonSnow88

This is for sure an issue in 2.0.1 hotfix 1, I've been using 1.3.5b for about a year now and specially tested thermal runaway by heating the hotend powering off...

> I found this comment on another site where they have a version of Marlin for the Ender 3 V2 similar to Jyers where someone pointed out their thermal runaway...

> I didn't want to start a firmware battle here by posting a link, but since there is no other way to get it to you here it is. https://github.com/mriscoc/Ender3V2S1/wiki...

It's a Wyze Cam v2 with webcam firmware, have used this for a few years on a Pi and haven't seen high CPU usage on it. I've tried passing the...

I may attempt to reinstall debian, with iGPU pass though before install. That may have been my mistake

That sucks but such is life.