JiBud
JiBud
Retry will probably solve the problem, because I am getting errors on different track/sector when I am re-reading disk again. In next week I will have another "direct disk" drive...
speed of disk is 300.7 rpm 3-5 errors per disk reading
the floppy disk created in this drive is readable without error in another (belt) drive, and ulticopy reads it without error Tested on FW 3.2 and 3.7 with same result....
Hi, Retry will probably solve the problem, because I am getting errors on different track/sector when I am re-reading disk again. In next week I will have another "direct disk"...
I checked your routine and there are alredy #100 attemps for reading sector -line 298 in ulticopy.tas I will do more tests
Thank you for explaining the reading mechanism. I saw nice reading routine from Linus Åkesson who created on fly GCR decoding, including a checksum. (https://www.linusakesson.net/programming/gcr-decoding/index.php) -but this part could eventually...
yes, keeping same electronics board - so it is not transfer issue in my case I have two 1541-II drives: A fine (electronics A + mechanics A) -all the time...
drive C with Sanyo amplifier and Sankyo mechanics -most quiet and reading 100% with ulticopy another new combinations: electronics C + mechanics B - disk read error starts here, even...