Jd1Ent

Hello, I have been following along with this thread. I recently installed an SKR mini E3 v2.0 on my Ender 3 V2. With your help and Youtube I have gotten...

> > I have been following along with this thread. I recently >installed an SKR mini E3 v2.0 on my Ender 3 V2. With >your help and Youtube I have...

I have it on the one labeled z probe.

> I don't see anything obvious in the config, how is your bltouch wired?, is it plugged in to the z min header or the bltouch header? I ended up...

> > > > I have been following along with this thread. I recently >installed an SKR mini E3 v2.0 on my Ender 3 V2. With >your help and Youtube...

Here are my notes on the display wiring. Pin 9 and 10 on the display end and pin 5 and 7 on the controller board end, do not get connected...


Fixed it for you. Use this one. Your pin 7 and 8 were backward. > 1 —> 1 > 2 —> 2 > 3 —> 3 > 4 —> 4...