JazzinSA
JazzinSA
OK, So a little feedback on this issue. I have changed the Marlin code to PWM maximum to 230 and not 255. Therefore the average current on startup to get...
I use a large number of these motherboards. I have found that the problem is not a marlin issue. Some motherboards is just way off. From a batch of 10...
I have looked at the SCH of this board and on MAJOR issue with this board is that the board uses serial to paradelle shift registers to increase the IO's....
Not so sure anymore that it is a hardware issue since the Z axis and extruder is not affected.
Ok. To all that have this problem. The solution is as follows. I'm not sure if it is in fact a motherboard issue or an Marlin issue but the problem...
> > Hi guys, i have the same issue with my tinybee v1.0 First i thought that`s it is TMC2208 fault. But it is not. I already tried to reduce...
Both these screens definitely work. I have used the 2004 and the 12864 screens on it. If the screens doesnt switch on its normally the ribbon cable plugs that is...
I think there are 2 different issues in this feed. The Baby stepping (as per the title) is an issue. I have a similar issue. The downloadable version of Marlin...