Jackson240193

UPD: The problem is precisely when executing the m600 command. ... If you write the m600 command in the gcode or simulate the situation with the end of the filament...

Hello. Tell me please. To test this I have to uncomment it here? **_Configuration.h_** > //============================================================================= > //============================ Other Controllers ============================ > //============================================================================= > > // > // Ender-3 v2...

### Observations (suddenly will help in solving the problem): If you insert a pause command m25 or m125 in the gcode, then the process of pausing and resuming printing will...

@RV-from-be Thank you very much! Your patch really works. Pausing from the display while printing works as it should. At the same time, during the pause, it became possible to...

@RV-from-be Yes, it works!!! Thank you very much!!! Now, when the M600 command is called or when the thread beat sensor is triggered, printing resumes without problems!!! I ask the...