JMyrng

Version 1.20n works for me with the ME81H.16. I flashed 1.19 via FTDI and then changed to the latest version via OTA. As described, I had to set up the...

> Could you explain me how did you flash Tuya module? Have you unsoldered it? No, I've done it with this explanation: https://github.com/klausahrenberg/WThermostatBeca/blob/master/Flashing.md#2-connection-to-device-for-flashing

> Is it the same as your problem? No, for me, when manually overwriting the automatic temperature, the change is not sent via MQTT. That is, from the thermostat to...

> You are using the Groove Multichannel sensor at 5V, right? Yes, that's correct. An additional info: the sensor was already on for quite some time. So maybe it's some...

> and then install it into rspamd using their [module here](https://github.com/spamhaus/rspamd-dqs) I'm still on version 3.4.0 and had the same problem as @GPConnect. As this version has no direct rspamd...

Sorry for asking a question so late in this old issue, but is the LoRa chip and the GPS powered off during deep sleep like mentioned in the second post...

> next week I will look into it Any updates on this topic?

I think I ran into a similar problem with a [JSON Draft 07 schema](https://json-schema.org/draft-07/json-schema-release-notes). Unfortunately I can't share it here, but basically it's structured as follows: ```json { "$schema": "http://json-schema.org/draft-07/schema",...

I have tested the direct connection with the Datahub via Modbus. The information that you see for each connected inverter is in this table, nothing additional.  With the hybrid,...