Jack Christensen

Hello Andreas, thanks for your suggestion. As you saw there was a previous suggestion, so I will consider adding this functionality due to popular demand ;-) I'm mostly concerned with...

Yes, I have been using it with S2C modules with no issues.

Yes.

This library works fine with the Pro Mini.

Still works very nicely for me.

If it doesn't work for you, then I'd raise an issue describing the specific problem. There are some good guidelines at http://www.sscce.org/

Yes, actually it's automatic. After sending data via a ZigBee Transmit Request frame (see ZBTxRequest) the transmitter will receive a ZigBee Transmit Status response frame (see ZBTxStatusResponse), which includes among...

If only a small amount of data is being sent, the XBee should hold it in a buffer until the Arduino reads it. It's a bad idea trying to power...

Right. The LEDs are not as bright because the Arduino pin cannot supply sufficient current. Hope your microcontroller is OK.

As long as configuration changes have been written to non-volatile memory, a reset will not erase them.