Lucas Fryzek
Lucas Fryzek
Schematic has OE assigned to pin 61 and CLR to pin 62 on the MAX2 device. It should be pins pin 60 for OE and pin 61 for CLR.
STM32F1X needs a 1.5k ohm pull up resistor to the 3.3v power rail
the USB blaster programmer needs to be powered by the board. It does not supply power. Therefore the Schottky diode on the vcc pin needs to be removed so that...
AMS1117 regulator in SOT-223 package is not supposed to have the output connected to the tab (unlike TO-252 package). Need to modify PCB and footprint for AMS1117 so that output...
USB connector is extremely difficult to solder by hand. Need to find a USB connector that is easy to solder by hand to use on board instead.
I was trying to run vkmark on a system where I didn't have a display connected, so I created a new unbacked window system that directly render to images that...
### Checklist - [x] My issue is specific & actionable. - [x] I am not suggesting a protocol enhancement. - [x] I have searched on the [issue tracker](https://github.com/ipfs/kubo/issues?q=is%3Aissue) for my...