Grumpytech4
Grumpytech4
The core implementation with Symbols at the bottom of the screen to identify the function of the 3 buttons would be a good crossover point for enhancing the touch interface....
When adjusting time values the touch area for each number to roll them up or down is too small and your finger covers the number you are changing so there...
I have the earlier GPS UNIT and the M5Tough. I'm willing to give it a go and see if it can also be supported. I do know the backlighting is...
The upload went without any problems, all functions work. The touch screen works and all settings are editable, the touch zones often activate the zone below where you actually touch....
Forgot to ad that the Camera being used is the Fujifilm X-M5
There is a physical power button, looking at the diagrams it is connected directly to the PMU (AX192) there is no connection to the MCU. When assembled the M5Tough obscures...
Battery indicator does not move from half charge. With the battery flat to the point of turning off it still showed the same as having charged overnight. After an overnight...
PWR button hack does not work on the M5Tough or the Core2 to lockout the touchscreen GPS appears to be operating the same on the Core2 and the Tough -...
In Gold inside its written as **M5 Core II** The battery is now on this device and is charging a lot better, terminal voltage 3.85V already from flat, charge current...
The current you expect, is that on the 5V USB supply or actual load on the nominal 3.7V battery? The GPS is quoted around 30mA but it's a 5v device...