GregValiant
GregValiant
@subcamera I'm going to go ahead and close this in favor of the previous report (noted by Asterchades). I hope you understand.
Thanks for the report. I've been doing triage here for about 3 years and I haven't seen a report on this behavior. Someone from the Cura team will be along...
In the MarketPlace is a plugin for "Extensive Support Logging" that you can install. I don't know if it will catch what is going on there. It might have some...
That didn't work for me. No matter what I have done, the handles stay "scaled to screen" rather that being scaled to the model. This might be a problem specific...
I like it. These are some thoughts. In your example of .4 line width and .6 line width - It looks like the 0.2 additional overlap on the walls would...
One thing to always remember is that "Everything affects everything.". Even small changes can have cascading effects on existing code. I don't see this as a "small change" but I...
I made a model of .2mm thick planes and arrayed them at .4 in the Z. The per model settings are "modify settings for overlaps" and as a Cutting Mesh...
I printed a test piece and visually it looks the same as any other print. I don't have any way to perform a tensile test. That would be the ticket....
@smartavionics Going from a .4 line width to a .6 will send the flow to 150% so that might well be a consideration. My test print was at a low...
I don't know if there is discussion at UM or not. The legal aspects might be sensitive. "Maximum Strength" is a really low number in a tension test, rotation test,...