Vladimir Sokolov

In windows 10 about the same problem, only writes an opening error In general, I noticed that if the file is saved in binary format, then it opens, if left...

In the current version of the gism, it scales as the screen zooms in and out. On earlier versions of the slicer, a small offset of the gizma did not...

September 2023, the problem with the music is still present. I play on Recalbox. I hope this will be fixed this year?

It seems to me that I found the cause of the freeze. But I have no idea what to do with it now. void EXTRUDER_TIMER_VECTOR() this function stops being called,...

Thanks for answering This is the point. L-factor freeze the same way. It also interrupt. Can this be fixed? it gives a lot of problems //----------------- L-factor includes the setAdvanceActivated...

It seems the problem with the timer is related to the settings of the extruder engine. I began to suspect the setting of EXT0_STEPS_PER_MM 2223 Can a high value of...

Thanks for the answer, I relied heavily on DUE's computational abilities, and I really thought that Due's performance would be enough to calculate such large values. I thought ~ 2000...

Hello . Switching the extruder is fast enough. But I do not know where the switching of the extruder is regulated. Acceleration and movement of stepper motors -3000 mm /...

Does this mean it's useless to install firmware on arduino mega now? I'm sorry, I was set up to test the new firmware.

OK I hope it will work soon I will wait for the firmware update