Gjeremie

I agree with all of your comments, A standard 150% 732us-2268us travel is needed for steering servo to have the full steering angle without using longer servo arms (rc car...

Hello I have exactly the same problem: - Radiomaster MT12 - the time resets to 2000-1-1 - RTC batt at 2.95V Problem happen with the nightly : mt12-36f2b6a.bin (9 february...

Please can someone could build for us several old nightly firmware for the MT12 (between the Nov 29, 2024 and now ) Dec 6 2024 : https://github.com/EdgeTX/edgetx/tree/3d1e7a914f729fffa77b15d3c3754bfa26f0e6e5 Dec 22 2024...

Ok I isolate the problem : The issue is in the commit #5693 or #5686 or #5617 or #5699 Because the commit 0ea41f2 work correctly and in the 3d1e7a9 the...

> [@Gjeremie](https://github.com/Gjeremie) , could you try [#5902](https://github.com/EdgeTX/edgetx/pull/5902) ? @3djc , I tried and It doesnt work

> I suspect the DFU issue is similar to that of the Zorro - i.e. a hardware > issue. With regards to the MT12, ATM I think it is important...

humm I dont really know the difference I build the .bin file then flash using this method: https://manual.edgetx.org/installing-and-updating-edgetx/update-from-an-earlier-version-of-edgetx-using-the-bootloader and after the flash i repeat these steps below 4 times to...

> You should try with DFU (connect USB while radio is off). You can use Companion to do it using Read/Write then Write firmware to radio OK i will try...

@3djc , another question: I only use these options to build the firmware : -DPCB=X7 -DPCBREV=MT12 -DDEFAULT_MODE=2 -DCMAKE_BUILD_TYPE=Release Is this OK ?

ok @3djc , I flashed via DFU your #5902 and: at first power on (after the flashing) the time is ok at second power off/on cycle the time is reset...