GimmiT

What you are experiencing most likely is a spike in current that is drawn. https://forum.prusaprinters.org/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/mk3-power-supply-clicking/

Are you sure this couldn't be a hardware problem. Had a similar problem today where my BLTouch was not properly connected to the motherboard on only 1 pin. Didn't look...

@ckiefer No zmin shouldn't be a problem as I have it stil installed and everything works. I don't know what it exactly could be. Try deactvating z_Probefeedrate and Multiple_Probing if...

Thank you for the feedback. Had to replace my cable too. If you haven't allready I highly recommend taking a cable that is not Extended with plugs but 1 cable...