JoAnn Manges

@no1jester Here are two wiring diagram that I hope will help: User **Thermistor table number 20**: ...

@no1jester Check your PT100 sensor with an Ohm meter. It should read around 100 - 200 Ohms at room temperature. If it does not read close to 110 Ohms at...

> @GadgetAngel, I have a question. If I use MAX31865 board, there are 2 modes available - hardware SPI and Software SPI. Which of two is better and why? >...

> Good day for everyone, > i was getting here by seeking for a similar solution, maybe you can help me too. I just installed a RPI4b beside my Ender3...

> > To setup the raspberry pi 4B, follow the instructions found in the SKR PRO V1.1 manual that I wrote. See appendix I, appendix J or appendix K, but...

> Hey guys how is everyone going with this i am struggling with configuring Marlin 2.0 does anyone have a config i can download? > > Ok i managed to...

> SKR V1.4 TURBO Stepper Driver Jumper Configuration_version V4.0.pdf corrupt file message @ProtomakerSprint **How are you trying to download the SKR V1.4 TURBO Stepper Driver Jumper Configuration_version V4.0.pdf?** This repository...

Can you make the 3D model available in PDF format?

> measure with a caliper / google pcb jumper spacings or something should be easy to find.. > > if you're in a rush.. carefully bridge them with a small...

Where is the schematic for this board?