JE

hmac and cartId are required for nearly all car operations. Inject them through the constructor instead of setters.

Bootloader

2

This ist not a Bug. More a question. Which bootloader the skr3 ist using? Where i can find it? I mean the custom bootloader Not the one from stm. Thank...

Cablechain hitting extruder motor

3

Hi there! I recently upgraded to an Galileo 2 extruder on a ldo voron 2.4. Since then I lost 5-7 mm on x since the cable chains are hitting the...

Power-Consumption in deep-sleep mode

8

Hey, i decided to measure the power-consumption of the board using an STLinkPWR. Here are the results of the stock ble firmware flashed on it: The Minimum Power-Consumption i was...

Add a ducumentation on how to calibrate the sensor

2

Hi, i don't know, but i think it would be beneficial to have a small guide how calibration can be done. I think there are more or less some default...