Marcin

Thanks for the tip about the voltage divider. This is what I found in my device, an AVATTO such as the one linked from the [Tasmota/Blakadder site](https://templates.blakadder.com/ME81H.html): 

Looking at the pictures you have provided, I'd say R7 is the most likely candidate. It is coupled using C11 as a low-pass filter. The fractional voltage is then fed...

If that is the case (4kB blocks), then it sounds like an obvious choice. I was not aware of it (getting too old, I guess :). And yes, as long...

Given it some more though, I appreciate the concept of transparency towards AmigaOS even more. Basically, I didn't think that modern OS's used the concept of "blocks" any more, and...

@hgw77: Thank you for the kind words. Before you do a driver to use the Raspberry Pi's audio output for the Amiga, you should consider the wide-spread criticism against the...

The RPi in question in that picture is the Model 3. Yes, you're right about it not having any stand-offs, but that is the result of numerous iterations and thorough...

We have based the design upon the RPi 3 as it is supplied by the RPF. For that model (and compatible ones), you will find the appropriate header component listed...

I made a DigiKey BOM a while ago that still should be valid: https://www.digikey.se/BOM/Create/CreateSharedBom?bomId=7822225 And to comment on _aiobofh_'s statement; yes, sourcing and building DIY hardware is not everybody's cup...

I agree. We should add that to the wiki. Today it's a bit cumbersome, because it requires specialized software. A preferable solution would be if there was a utility, command-line...

This enhancement did not make into the 1.1 update. It is still pending for now; there is no committed time-frame.