ERCF_v2

ERCF_v2 copied to clipboard

After going back and forth with @gneu42, we found out my ECAS couplers were slightly undersized, as they were slipping loose from the filament blocks. These were sourced from Bondtech,...

EllaFoxo

[User Mod] No Bypass End Block

3

As discussed with @moggieuk, here is a user mod to accomplish what I was trying to do.

EllaFoxo

For keeping PTFE tubes tidy on larger builds.

EllaFoxo

Narrow Apron LED user mod

2

I made a mod to use the apron leds on a v1.1 (upgrade) with narrow thumper blocks without loosing a gate.

rrz-dev

Toolhead Sensor Part Mismatch

1

The 2x sensor options, with and without filametrix, differ drastically at the top gear sensor. There is no hole to visibly see the position of the ball bearing, and it...

EllaFoxo

Extruder sensor too loose - false negative

2

Hello all, [2 toolhead sensor](https://github.com/Enraged-Rabbit-Community/ERCF_v2/blob/master/Recommended_Options/ERF_Filament_Cutter/Stls/1_Toolhead_And_Entry_Sensors/SB_CW2_Body.stl) Extruder sensor malfunctions, gap between wall and ball is a bit too big so I got false negative signals. Second issue is holes for M2...

bartoszwas

Wrong hole size on Gear Box Front

1

 The holes showen in Picture are to big. the screw M3x20 should go in the plastic, but the hole is 3,1mm. this doesn´t make sense.

gabber130779

Introduction / Print Guidelines - update first print file name ERCF_Calibration_Tool.stl to Calib_Test.stl

1

Page 4 of ERCF v2 BUILD GUIDE VERSION 2024-04-01, it is referenced a file named ERCF_Calibration_Tool.stl. This file is not available on the repo, and page 14 the drawing refers...

tiwipewo

Would it be possible to post the cad drawing for the depressor mount for the filametrix? I have steel backing rods rather than titanium or linear rails and the mounting...

ksteddom

Move the electronics box mount for the ERCT back into the recommended mods section

kwalters3