EldRick

I have also experienced this issue. After PID setting using 16.08 firmware, the extruder temp would soar 8C over setpoint initially. I used Printrun to run the PID tuning, and...

I also had underextrusion and backed out 17.2.1. I'll reinstall and check the esteps.

Just realized I've seen the same thing, but had overlooked it.

I haven't tried a long print, but the Move Material three-click issue is still there in 16.12.1 If memory serves, on 16.8.2 it did not make the clicky sound if...

The triple-click to get Move Material to work is still there in 16.12.1

Same as an issue I reported recently. I do not turn the LCD off.