Nathaniel van Diepen
Nathaniel van Diepen
> You might have had the pogo pin in wrong direction. I got this same "over-current" message when the "v-bus" was on the far side of usbc. However for me,...
> ... how do I know for sure it's fried? > > I always made sure it's in the right direction before, but no luck. so I tried the reverse...
How are you securing the pogo connector? Doesn't it have enough pressure?
> I have the same issue, I'm using spring-loaded pogo pins (I'm pretty confident in the connection and I tried jiggling the board, etc.), connected to a Raspberry Pi. The...
Have you tried using a different port on your computer, or restarting it?
Do you see anything when connecting your reMarkable normally without pulling the pin down?
I'm guessing in these pictures you are just using the device normally and not trying to get it into recovery mode? The reason I'm assuming this is because I see...
> ARM based macs can't use the included uuu_mac. Did you try with Rosetta? > > But have no fear - uuu is now available via homebrew. > > Please...
Did you stop, or disable the service? If you stopped it, just hold the power button for 10+ seconds, and then power it on again. If you disabled the service,...
> I know in the instructions says to use linux but by any chance do you know if linux wsl in windows works? In theory, you might be able to...