Ed Smallenburg
Ed Smallenburg
It is possible, in fact I tried that. But the difficulty is the synchronisation of the sender with the receiver(s). If a receiver is too slow (bitrate is a little...
In that case it would be possible, I think.
Maybe switching to version 2 helps.
Please try the V2 version of the radio. I tested the station, no problem. As you can see, the queue is filled with almost 500 chunks. It may have something...
It may not be a network isssue, but it may be a network difference. So if you have the opportunity to test with a different network, it might help to...
Als je een gescheiden voeding hebt voor de versterker, dan moet de GND van de versterker niet verbinden met de GND van de ESP32, maar met de common van de...
Good idea. I will add this to the project later.
I've build the radio with your PCB. It worked without problems. The pins used are the same as my default settings. I'm still waiting for the PAM amplifier to arrive...
Note that changing defaultprefs.h does NOT have direct effect on the settings. Use the config page of the webinterface to change all settings including pin_vs_dcs.
Use the bare ESP32, without any wires or connections. Then use a USB cable to connect the ESP32 to your PC running the Arduino IDE. Upload the sketch. Replace the...