Eclypse3D

It is very odd that in 2022 they are putting out a LCD display that cannot run DPMS, turn off the backlight, and wake up out of sleep. Come on...

Hatchbox abs printed @250c. Chamber temp is around 50-55c normally while heat soaked. About 200hrs printing. Had to retighten center rail 4 times already and as time went on started...

@Badnoob-327 I am running the Revo Voron, which has been doing well till after I installed TAP. Everything was been relatively fine, then about a week after I started seeing...

> We tested this using 50-60C chamber temps at 23 hour/day print cycles, on 8 printers, for weeks though. and none of those printers experience rail loosening or part warping....

The CB1 according to their site does support the screen but only v2.2 of the board, the older version must use the canbus MCP2515 I believe to use the screen......