EarthBreaker

Hi there @raffa1993! I'm trying to solve that problem as well. Now currently using an Arduino Pro Mini since that's the medium being used by the library owner. I don't...

@raffa1993, yea, I'm in that thread of yours, as 69.eddy. Hopefully we can get this up and running.

Right now, I've had problems running most of the examples. Could it be due to the way I power my DWM1000? Right now, its not really connected to an external...

@ttaber, I'm here. So you roughly know my board and set up. When I tried to run the program above and check the serial monitor, I saw unknown symbols. The...

@ttaber, I think I understand it alot better now. At first I didn't really quite get why there is a need use LLC to shift down from 5V to 3.3V...

@ttaber, Good day Sir. I just purchased two sets of Arduino Pro Mini (3.3V) with an FDTI Basic Breakout Board so that I can try to recreate the results you...

These are my pin connections at the moment.  I've changed "No Line Ending" to "Both NL & CR" as you've advice but I still somehow receive the same error....

Ah I see, I saw on the datasheet that the max current needed can go up to 140mA to 160mA on Channel 5. The board (Pro Mini) only provides 40mA....

@ttaber, i'll let you know how I fare in a couple of hours. Gonna catch some shut eye first.

@ttaber, so far still unsuccessful. I could not purchase the power supply you recommended on short notice, so I decided to power the DWM1000 from an Arduino Due pins (3.3V,...