ETE-Design

[MOUNT] ADIMLab Gantry-S

4

**Is your printer similar to any that currently already have support?** Like the Ender-3 Just a smaller cover / fan also screws to hold it is on the top **What...

[FR] ESP3D - 3D Printer Interface

14

I'm really not into programming... But will it be possible to make it work with ESP3D - Firmware / ESP3D-WEBUI - GUI, used to control a 3D Printer, so it...

Klipper

1

Is it possible to make it work with OctoKlipper, an plugin for Octoprint...

Feature Request: ESP3D

7

I'm really not into programming... But will it be possible to make it work with ESP3D so it can send status and and let you change settings direct from the...

MKS WiFi?

19

So to understand it correct it is not possible to just insert the MKS WiFi Module in the connector, so have to router RX / TX direct to the board?...

Super Slicer - Non Planar

6

@Zip-o-mat Will it be possible to add this to the Super Slicer? https://github.com/supermerill/SuperSlicer

Raspberry Pi HQ Camera

21

Hi Kamil. Support for the Official Raspberry Pi HQ Camera, is that something you can add to the Streamer? Or is it already supported? Regards

CSI-2 2 & 4 Lane Support

12

Hi. The Raspberry Pi 5 seems to Support CSI-2 - 4 Lane, and there is already some camera chip that support 4-lane. Wouldn't it give a performance gain to support...

Feature Request: Control Motor

8

Hi. Would it be possible to add a way to control a Motor -> Backwards / Forward? Connected to GPIO?