Durahl
Durahl
Greetings, Today I've finally managed to dedicate some time going after the cause of the KlipperScreen interference problem that I'm having every once in a while đŠ The issue has...
Today I upgraded from an AfterBurner 4.0 PCB to the New 2-Piece PCB StealthBurner and upon powering on the System both Tool Head FANs spun up to ( I assume...
Greetings! Been using the ERCF / ERCP for I think like 9 months or so and the StealthBurner / ClockWorkd2 on my Voron 2.4 since it was released to the...
Ever since the Beta release of the SB / CW2 Combo I was having an issue that would creep in as time would pass, sometimes after weeks, sometimes during the...
Is it possible - with a Gear Ratio MOD to the ERCF - to run both the ERCFs Gear _**Motor**_ and the Tool Heads Extruder _**Motor**_ in Sync with each...
Greetings! I've been using PGC for a while now, but I still can't get over the fact that the PAN is bound to the LMB while ORBIT is bound to...
### What happened? Greetings! There's two issues I've come across concerning Support Interface Generation one of which I found an old entry about supposedly fixed which I guess had a...
The on Page 27 of the Manual mentioned `Fun Fact Voidsâ˘` didn't appear with my settings of **SuperSlicer** and since I couldn't figure out what settings was responsible for them...
#### Description Being a long-term UGC-P user I decided to give CNCjs a try because of the more elaborate macro functionality allowing for a little more work convenience with things...
I'm kinda having an issue with the in the `ercf_software.cfg` found `long_moves_speed` default setting of `100 mm/s` not working out for me anymore requiring me to lower it down to...